EG1069X
Engine Electronic Governor (Soft Start Ramp Type)
Home > Electronic Governor > EG1069X
The EG1069X is an universal and compatible generator governor / engine speed controller replacement for the Barber Colman DYN1-1069 series. This engine governor can be installed on both diesel and gas generator with non-built in Actuator with resistance below 5 Ohm.
» Brochure | Manual | 3D DisplayFeatures
- Smoke Limit Controller
- For Use In Both Gas & Diesel Engines
- Excellent Speed Stability & Performance
- Outstanding Vibration-Proof Design
- Anodized Finish For High Reliability
- Available For Use With Isochronous Generators & Remote Control In Paralleling
Specifications
| Operating | 12 or 24 VDC ± 20% select by DIP switch |
|---|---|
| Output | Quiescent 80 mA Stall 15 A |
| Power Input | Voltage 12 or 24 VDC ± 20% Rated above maximum actuator stall current |
| Speed Band | ± 0.25% at steady state |
| Temperature Stability | Better than ± 0.5% between -40~75 °C |
| Ramp Time | 0~10 Sec. |
| Remote Speed Adjustment | ± 5% with 5 KΩ potentiometer |
| DIP Switch Description | SW1 : OFF for Diesel Engine , ON for Gas Engine SW2 : OFF for DYNA8000 Actuator , ON for DYNA8200/8400 Actuator SW3 : OFF for 24V I/O , ON for 12V I/O SW4 ON : Compatible with DYN1-10692 SW5 ON : Compatible with DYN1-10693 SW6 ON : Compatible with DYN1-10694 SW7 ON : Compatible with DYN1-10696 When one of the SW4~7 is ON, set others of SW4~7 OFF. |
| Governor Controls | DROOP : Droop Rate Adjustment Gain : MPU Output Gain Adjustment I : Engine Stability Adjustment Speed : Engine Speed Adjustment Start-Up Fuel : Start-up Fuel Adjustment Ramp Time : Soft Start Adjustment |
| Environment |
|
| Weight | 0.86 Kg ± 2% |
Compatible Barber Colman Products
| Type | Input Signal Frequency |
|---|---|
| DYN1-10692-000-0-12/24 | 250~1200 Hz |
| DYN1-10693-000-0-12/24 | 1200~2500 Hz |
| DYN1-10694-000-0-12/24 | 2500~5000 Hz |
| DYN1-10696-000-0-12/24 | 5000~9500 Hz |
Mechanical Specifications
Related Products
 EG1065X |