EG2000
Universal Electronic Engine Governor Controller
The EG2000 is a universal generator governor / engine speed controller equipped with Smoke Limiting, & Idle Speed. Suitable for diesel, gas and natural gas engines with Built-in & Non-Built-in PTs Pumps, also can be used with Low Current, Electric over Hydraulic Oil Pumps Type Governor Actuators. It's compatible with following model. Cummins 4913988-BI, 3419988, 3098693 and 3044196 AVR. GAC ESD5500 and ESD5500E. Woodward EPG P/N 8290-189,8290-038, and ESD5500E K77255.
EG1065X and EG1069X have ceased production and will be replaced by EG2000.
● Brochure ● Manual ● 3D Display
Features
- Works on a wide ranges of MPU/flywheel frequencies
- 15 Amp Max Output
- Suitable for all types of diesel and Gas engines
- High Sensitivity and stable at Low Frequency Variations
- Moisture, vibration, and rust protected, Epoxy encapsulated electronics
- For Use With Isochronous Generators & Automatic Paralleling PLC controls
- Idle Speed Adjustment and connections for a Remote Speed POT
Specifications : EG2000
| Operating Voltage | 10 VDC to 30 VDC |
|---|---|
| Output Current | From 0.5 Amp to 15 Amp |
| Frequency Range | 600 Hz ~ 9500 Hz (PMG Signal) |
| Idle Speed Frequency | Adjustable From 30~85% of normal |
| Speed Band | ± 0.25% at Steady State |
| Temp. Stability | Between -40~85 °C Better than ± 0.5% |
| Remote Speed Adjustment Range (2 mode) | Adjustable Range ± 5% with 5 KΩ potentiometer |
| Ramp Time | 3 to 20 Sec. Adjustable |
| Operation Environment | Operation Temp. : -40~85 °C Storage Temp. : -40~85 °C Relative Humidity : Maximum 95% Vibration : 3G @ 100~2 KHz |
| DIP Switch Description | SW1 : ON 600~1200 Hz SW2 : ON 1200~2500 Hz SW3 : ON 2500~5000 Hz SW4 : ON 5000~9500 Hz |
| Governor Controls | DROOP : Droop Rate Adjustment GAIN : MPU Output Gain Adjustment Int. : Engine Stability Adjustment RAMP-TIME : Soft Start Adjustment SPEED : Speed Adjustment IDLE : Idle Speed Adjustment |
| Dimensions | 147.0 (L) x 114.0 (W) x 40.0 (H) mm |
| Weight | 690 g ±2% |
Mechanical Specifications
EM81/EM121