GCU-10 Generator Controllers

GCU-10

Generator Control Unit

The GCU-10 is an economical genset controller, giving high reliability for much less than similar controllers. It has adjustable settings to enable it to work with any type of generating set and comply with different engine conditions and protections. Optional 12V/24V relay boards (GCU-11R) are available for simplifying wiring and connections.

Features

  • Microprocessor based design
  • LED graphic interface, displays generator status and failures
  • Modular design, quick installation
  • Adjustable settings to enable it to work with any type of generating set
  • Waterproof front panel with UV protection
  • Provide IDLE control for Elec. governors
  • Five adjustable time delay potentiometers
  • Five DIP switches for specification setting

Specifications

  • DC Supply
  • DC Voltage 9 to 36 Vdc
  • Alternator Input Range
  • AC Voltage 5 to 300 Vac
    Frequency 50 to 60 Hz
  • Fuel Solenoid Signal Output
  • 5 Amp @ 12/24 Vdc
  • Start Signal Output
  • 5 Amp @ 12/24 Vdc
  • Warm up Signal Output
  • 5 Amp @ 12/24 Vdc
  • Accessory " ON " Output
  • 5 Amp @ 12/24 Vdc
  • Idle Control Conductor Capacity
  • 5 Amp @ 12/24 Vdc
  • Power Consumption
  • Under 3 VA on Auto
  • Operating Temperature
  • -20 to +70 °C
  • Relative Humidity
  • Max. 90%
  • Panel Cut-Out
  • 66.0 x 66.0 +/-0.5 mm
  • Dimensions
  • 72.0 (H) x 72.0 (W) x 50.0 (D) mm
  • Weight
  • 166 g +/-2%

Protection & Alarm Status Indicators

  • Start Failure
  • High Water Temperature
  • Low Oil Pressure
  • Overspeed
  • Underspeed
  • Emergency Stop
  • Extra Prog. Input
  • Low Battery Voltage

Adjustable Timers

  • Engine Pre-Heat
  • 2 to 30 seconds
  • Starter Cranking Time
  • 1 to 15 seconds
  • Energize to STOP
  • 1 to 30 seconds
  • Engine Idle (Governor)
  • 0 to 300 seconds
  • Engine Cool-down
  • 0 to 300 seconds

Downloads

Dimensions

Rotating Image