ECU-02

Generator Set Control Unit

The ECU-02 is one of Kutai's best selling Micro Processor based design Digital Genset PLC Control Unit. It offers full engine and generator protections with simple operation and programming without the use of PC connection or software.

Features

Micro-Processor Based Design
Easy-to-Read Large LED Display
Compact Size with Vibration Protected
Provides Full Engine & Generator Alarms Signals & Shut Downs
2 Wire Remote Start & Stop
Front Panel Mounted With Manual, Off & Auto Switch
Provided With Easy-to-Install Auxiliaries, Relays & Fuses
No Need for Magnetic Pick-up to Check Over Speed
Simple Operation & Programming (There is no need for PC connection or software--all operation can be done directly on ECU-02)
No Battery Power Needed to Maintain Program (Customized settings are auto-saved into memory and will remain even when power is off)

Specifications

Power Input	Voltage 9~30 VDC
Sensing Input	Voltage 15~380 VAC , 3 phase 3 wire Frequency 50~60 Hz
MPU Signal Input	Voltage ± 2V to ± 70V Peak Frequency Min. 100 Hz , Max.10 KHz
Control Signals	Current 2.5Amp with input volts
CT Specifications	Burden 2.5VA CT Range Min. 25A / 5A , Max. 3000A / 5A
Power Dissipating	Max. 7 Watt
4 Digit 7 Segment Easy-to-Read LED Display	Programmable Display with 3 Phase Volts,Amp & Freq. Failure Alarms Status Battery DC Voltage Indicator Total Engine Operating Hours & Service Alarm Internal Program Settings & Status
Protection & Alarm Status	Engine Start Failure Engine Over Speed MPU Failure Abnormal Generator Voltage Low Engine Oil Pressure Emergency Stop Activated High Engine Temperature Generator Over Load Low Fuel Level Low DC Voltage
Operating Temperature	-25~+75 °C
Panel Installation Cut-Out	137.5 ± 0.5 mm x 67.0 ± 0.5 mm
Weight	372 g ± 2%

Mechanical Specifications

Auxiliaries

	ECU-11(12V) / ECU-22(24V) Relay Module for ECU-02 12V & 24V		PTU-03 Isolation Transformer Module for ECU-02
	ECU-40 Harness for ECU-02 Connection

GCU-2000	GCU-10	DSP-10	ECU-04/05	AMF-10
GCU-20	RA-20	GCU-100	GCU-30